ASSISTED STEERING SYSTEM
The unique EZ-Steer system turns the steering wheel for you by combining a
friction wheel and motor with GPS guidance from the EZ-Guide™ Plus
lightbar. Now, while the EZ-Steer system keeps you +/- 6-8 inches on line in
any terrain, you can focus on many different tasks, such as spray or planter
performance. Basically, the EZ-Steer system gives you time to ponder the
fuel and input savings of straighter rows -while reducing driver fatigue.
EASY TO INSTALL AND OPERATE
The EZ-Steer system is easy to install, setup and use. Installation can be
completed in less than 30 minutes with 1 wrench. No need for complex
hydraulic interfaces. You can remove the system from a vehicle in a few
minutes and never know it was fitted.
HANDS FREE ON ROUGH AND ROLLING TERRAIN TOO!
Trimble's exclusive T2™ terrain compensation technology gives the EZ-Steer
user +/- 6-8 inch pass-to-pass accuracy and smooth hands-free driving on
rolling, sloping or even rough terrain such as ditches waterways and
terraces. This optional feature uses two accelerometers and two gyroscopes
to compensate for roll and yaw. Information from these sensors, located in
the steering controller, is used at 10 times per second to compensate the
GPS position for sloping and rough terrain - as illustrated by the diagram
below.
Additional Information
-Price of Ez-Steer $3495 (list price) without T2 compensation, $4395 with T2
You can also upgrade to the T2 at a later time for $995
-EZ-Steer can be used with your existing GPS receiver assuming it outputs the correct data.
-The EZ-Guide plus uses the WAAS signal for corrections (accuracy of 4-8 inches, 3 feet repeatable). For higher accuracy operations it is suggested to use the OmniSTAR HP or XP signals. To use these signals you will need a 252 receiver or 332 receiver.
Accuracies
| Signal | Pass-to-Pass | Repeatable |
| WAAS, CG Beacon | 8-10" | 3 feet |
| Omni-Star XP | 3-5" | 7" |
| Omni-Star HP | 2-4" | 4" |
| RTK | 1" | <1" |
-For customers with older guidance systems, Brandner Mapping will have a trade in program available, call for more information.
-Call to set up a demonstration on your farm or our office.
Ez-Steer Wiring Diagram
